Eq board for them are $20 each
The reason for bringing these in is for the fellow DIY-minded folks, , these can be cut down the middle to achieve a squarish block @ 3x3 config vs the 1x6 config. (long narrow).
Once the middle aluminum busbar has been cut u can bend it up slightly by a few degrees and drill a 6mm hole on both cut ends.
Then get yourself a piece of say 20m x 3mm aluminum flat and again drill them 6mm holes and use an m6 bolt to bolt it together, otherwise TIG weld it.
Then get yourself a piece of say 20m x 3mm aluminum flat and again drill them 6mm holes and use an m6 bolt to bolt it together, otherwise TIG weld it.
As with DIY, they can be paralleled up and installed in a nice DIY box for a giant power dump, cranking, or car audio doof doof!
Add them in series for 24v use etc...
They are available in three connection (pos & neg) config (will be shipped randomly)
The photos attached show A) config
A) NEG (black) post and POS (bent up busbar) which u can drill a hole for a bolt.
B) POS and NEG are bent-up busbars which u can drill a hole for a bolt
C) POS (red) post and NEG (bent up busbar) which u can drill a hole for the bolt
Dimensions:
L 370mm W 60mm H 180mm (top of post)
L 370mm W 60mm H 180mm (top of post)